Differences

This shows you the differences between two versions of the page.

--- project_notes:localtalk_bbb_cape [2018/02/11 16:12] – doug
+++ project_notes:localtalk_bbb_cape [2018/02/11 17:04] (current) – doug
@@ Line 9: / Line 9: @@
       * Added 10K pulldown to keep LPC MCU in reset until BBB explicitly asks it to start.
       * Fixed mistake where I left A/!B channel selection pin floating on the SCC.
-  * Current known issues:
+      * The RX pins of the transceiver were wired to the TX pins of the Mini-Din-8 pinout, and vice-versa. This means a straight-through Mini-Din-8 cable would have been needed to connect between a Mac and the cape, which is not typical. Typical printer cables are crossover. This also means that LocalTalk transceivers connected directly to the cape would have had RX and TX backwards.
-      * The RX pins of the transceiver are wired to the TX pins of the Mini-Din-8 pinout, and vice-versa. I should fix this before ordering revision 0.2.